Custom Audio / Suhr ISO Line Out Box
En stock !

What it is:
The ISO Line Out box is used to provide a transformer-isolated signal from any guitar amplifier speaker ouput jack. One common purpose is to provide a line level signal that feeds an effect processor. The wet only output of the effect can feed another amps effect loop return or power amp with speakers to have a Dry/Wet setup or even Wet/Dry/Wet.
What it is NOT:
The ISO Line Out box is NOT a load box. In other words, the amplifier MUST have a speaker connected at all times. The ISO Line Out box is not a speaker cabinet emulator.

Operation:
Connect any available speaker output jack to one of the Speaker Thru jacks on the ISO Line Out box. If the amp has only one speaker output jack, connect this to one of the Speaker Thru jacks on the ISO Line Out box and plug the speaker into the other Speaker Thru jack. Connect the Line Out jack to a balanced or unbalanced jack of your mixer, effect or recording device. Set the appropriate level.

Line Out:
The Line Out jack is wired for balanced or unbalanced connections. The transformer is wired to the tip and ring connections of the jack. The cable shield is floated and can be referenced to the box ground ONLY when a balanced cable is used.

Phase Switch:
The phase switch is used to invert the phase of the signal. Set the switch in the up position to invert the phase, down for normal phase.

GND Ref Switch:
The ground reference switch can be used to reference the box ground to the Line Out cable ground. This should ONLY be used with the use of a balanced cable. For mono cables, leave this switch in the down position. Pour en savoir plus


EUR 180,00

Custom Audio / Suhr MiniMix
En stock !

The Suhr MiniMix is the first professional tone tool product from John Suhr that significantly improves the performance of your guitar rig. Used by pros like Scott Henderson and Mike Landau, the MiniMix essentially converts the serial effects loop of your amp into an extremely transparent parallel effects loop that will not mess with the purity of your amp signal whatsoever. Designed by John Suhr utilizing only the highest grade audio components, the MiniMix features better than 0.004% total harmonic distortion and noise floor along with an extremely flat frequency response covering 20Hz to 20 KHz.

You will be amazed by the improvement to the overall sound quality of your rig by connecting the MiniMix into the effects loop of your amp. You get back your precious amp tone and simply layer the effects of your favorite processor over it to taste. Simply connect "Send" of your amp´s loop to the "In" of the MiniMix. Connect the "Send" of the MiniMix to the input of your processor and the output of the processor to the "Return" of the MiniMix. Connect the "Out" of the MiniMix to the "Return" of your amp and you're ready to rock. Make sure the processor is set to 100% wet. You can control the balance between the dry amp tone and wet effects tone with the output level of your processor.

The MiniMix assures that your amp signal is not degraded by ADA converter in your processor. Now you can play with the peace of mind that the pure guitar-amp signal that you've worked so hard to attain is not compromised by suspicious circuits in various effects units. It's like converting your simple mono amp rig into a sophisticated multi-amp "wet-dry" rig without the hassles and the added bulk and weight. Add the MiniMix to your rig and hear the difference you didn't think was possible in a simple one-amp rig.

EUR 180,00